Cctv Camera Cable

Cctv Camera Cable

To maximize cameras coverage and get the most out of the CCTV system for least amount of money minimize number of it by placing cameras in strategic places, unless complete area coverage is needed. Avoid overlapping camera views, do not install them with source of light directly in front of it and do not place infrared cameras pointing at each other to eliminate risk of overexposure. These are the most common mistakes that need to be avoided. After the initial camera locations are predetermined, lets look at cable placement. Make sure that it is actually possible and practical to run cable to each location, if running the cable to any camera location is for some reason impossible opt-out for alternate location.

Wiring: The most time consuming and important part of any camera installation is wiring. Plan your installation carefully to minimize cable lengths and insure good quality video signal. Never run cables alongside high power electrical lines, at least 12" spacing between video cable and power lines are recommended. Keep the cable lengths below 400ft and use good quality cable, most people take the cable for granted, but it is actually very important aspect of any installation. The CCTV system is only as good as its weakest component. I usually stick with RG59U with power Coleman cable (YES it is US made) sometimes called Siamese type cable. It is combo cable and will transmit video and power, as an alternative it is sometimes possible to use less expensive RG6 standard coax cable with separate run of 18/2AWG for power.

Cctv Camera Cable